Embedded Online Conference 2022

share on: 
Miro Samek at EOC-2022
Table of Contents

The Embedded Online Conference has emerged as the one of the most important learning events for embedded software in the U.S. This year, Quantum Leaps’ Miro Samek will present again. This year, the subject is:

NOTE: You can use the promo code QL to save $100 on the conference registration fee.

Testing of Event-Driven Embedded Software with Python

Testing event-driven software typically involves injecting events to the system and verifying that the software reacts by executing the expected sequence of actions. These actions might be quite complex. For example, a single transition in a hierarchical state machine might trigger several exit actions from the source state configuration, followed by entry actions and nested initial transitions into the target state configuration. The actions themselves might involve interactions with multiple hardware components, such as toggling GPIOs, sending data through various interfaces, etc.

Traditional Testing with Mocks

In traditional unit testing frameworks, the verification of such potentially complex interactions typically requires applying mock objects as the test doubles for the various hardware components. But even though generating mocks can be automated, it’s difficult to verify sequences of expected interactions among multiple mocks (multiple hardware components). Also, working with mocks reverses the natural sequencing, because the expectations must be specified before the actual call to the CUT (code under test).

Testing Based on Software Tracing

This session will show a more intuitive approach, conceptually similar to “debugging with printf”, where you instrument the code with printf statements to output the software trace information. You then run the CUT with a controlled set of inputs, and examine the produced trace to determine whether the CUT operates correctly. The main differences from using actual printfs will be: (1) that the much more efficient software tracing mechanism will be used instead and (2) that both generating the inputs and the checking of the trace output will be automated.

This approach has many interesting implications:

  • It separates the execution of the CUT from checking of the “test assertions”. The embedded target is concerned only with running a test fixture that calls the CUT and produces the trace, but it does not check the test expectations.
  • Checking the generated trace output against the expectations is performed separately on the host computer and can be done in a different programming language (e.g., Python) than the CUT (C or C++).
  • Virtually all test doubles can be implemented as simple “spy” test doubles without the need to applying mocks or other complex test doubles. Verifying trace output from multiple such “spy” test doubles is trivial.
  • The testing process follows the natural sequencing where the generating of inputs to the CUT is naturally followed by the expectations of the performed actions.

About the Session

This session will utilize hands-on demonstrations of the QUTest (pronounced “cutest”) unit testing harness running on both the host computer and STM32-NUCLEO board. Specifically, you will see a comparison between the traditional approach with a mock test double and the QUTest approach with software tracing and a “spy” test double.